ASTM D4225-03

    Standard Specification for Styrene-Butadiene Sheeting (Withdrawn 2009)

    Withdrawn Standard: ASTM D4225-03 | Developed by Subcommittee: D20.19

    WITHDRAWN, NO REPLACEMENT


      Format Pages Price  
    PDF Version 4 $44.40   ADD TO CART


    Withdrawn Rationale:

    This specification covered styrene-butadiene sheeting in thicknesses of 0.25 mm (0.01 in.) and greater. Sheeting conforming to this specification was intended for use in instrument housings and applications requiring resistance to impact. Methods of fabrication may require that the sheet be drawn or bent.

    Formerly under the jurisdiction of Committee D20 on Plastics, this specification was withdrawn in April 2009. This standard is being withdrawn without replacement due to its limited use by industry.

    1. Scope

    1.1 This specification covers styrene-butadiene sheeting in thicknesses of 0.25 mm (0.01 in.) and greater. Sheeting conforming to this specification is intended for use in instrument housings and applications requiring resistance to impact. Methods of fabrication may require that the sheet be drawn or bent.

    1.2 This specification covers natural and colored sheeting.

    1.3 This specification covers quality requirements that include degree of orientation, amount of warpage or twist, dimensions, tolerances, and workmanship.

    1.4 The values stated in SI units are to be regarded as the standard. The SI units given in parentheses are for information only.

    1.5 The following precautionary statement pertains to the test method portion only, Section 12, of this specification: This standard does not purport to address the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.



    DOI: 10.1520/D4225-03

    ASTM International is a member of CrossRef.