ASTM D4131 - 84(2014)

    Standard Practice for Sampling Fish with Rotenone

    Active Standard ASTM D4131 | Developed by Subcommittee: D19.24

    Book of Standards Volume: 11.02


    Buy Standard (PDF)
    3 pages
    $37.00
    Buy Standard (Print)
    3 pages
    $37.00

    Historical (view previous versions of standard)


    ASTM D4131

    Abstract

    This practice covers determination of the quantitative and qualitative species composition of fish in a specified area. The successful use of this technique is dependent on: (1) preventing fish from escaping the sample area and (2) retrieving all affected fish, which may take up to three days. This practice is useful in both short- and long-term studies for management and impact assessment purposes. The sample area is blocked off with a small mesh net(s) and the volume of water to be treated is calculated. The required quantity of rotenone is diluted and distributed throughout the water column in the sample area. All fish should be affected and they should be collected for processing.

    This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

    1. Scope

    1.1 This practice covers determination of the quantitative and qualitative species composition of fish in a specified area. The successful use of this technique is dependent on: (1) preventing fish from escaping the sample area and (2) retrieving all affected fish, which may take up to three days.

    1.2 Advantages:

    1.2.1 Easily detoxified.

    1.2.2 All native freshwater fish are susceptible, but it has low toxicity to mammals and birds.

    1.2.3 At low concentrations fish toxicity depends on species, age, and size.

    1.2.4 The suffocating action is reversible.

    1.3 Limitations:

    1.3.1 It is less effective in cold (below 20°C) and highly alkaline water.

    1.3.2 Smaller fish and those without air bladders usually do not float.

    1.3.3 Completely random selection of sample areas is not possible.

    1.3.4 Overkill beyond sample area can sometimes occur.

    1.3.5 Food web organisms may be eliminated.

    1.4 Applications—this practice is useful in both short- and long-term studies for management and impact assessment purposes. It is adaptable to both lotic and lentic situations in littoral and limnetic areas.

    1.5 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

    1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazards, see Section 6.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D1193 Specification for Reagent Water


    ICS Code

    ICS Number Code 67.120.30 (Fish and fishery products)

    UNSPSC Code

    UNSPSC Code 50121500(Fish); 77101500(Environmental impact assessment)


    DOI: 10.1520/D4131

    ASTM International is a member of CrossRef.

    ASTM D4131

    Citing ASTM Standards
    Back to Top