This test method offers a convenient alternative to solvent extraction for the approximate determination of top-coating bitumen and adhered aggregate in roofing samples, particularly when the bitumen is coal tar pitch.

1. Scope

1.1 This test method covers the determination of the bitumen content of adhered aggregate surfacing on a roof, and the approximate mass per unit area of the flood coat and adhered aggregate.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability and regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

D71 Test Method for Relative Density of Solid Pitch and Asphalt (Displacement Method)

D2829 Practice for Sampling and Analysis of Existing Built-Up Roof Systems

Keywords

aggregate; asphalt; bitumen; built-up roofing; coal-tar pitch; Adhered aggregate; Aggregate content; Bitumen-aggregate mixtures; Bitumen content; Bituminous roofing materials; Density--roofing/siding materials/applications; Mass per unit area; Roofing membranes; Top-coating bitumen;

ICS Code

ICS Number Code 91.100.50 (Binders. Sealing materials)

Citing ASTM Standards

[Back to Top]