This specification covers the fabrication and jobsite requirements for deformed and plain steel reinforcing bars with protective epoxy coating. The fabrication of steel reinforcing bars after coating shall meet the requirements prescribed. The storage, handling and placement at the jobsite of epoxy-coated steel reinforcing bars shall meet the requirements prescribed. The repair method of damage incurred during fabrication and incurred during shipment and handling at the job sites shall meet the requirements prescribed.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 This specification covers the fabrication and jobsite requirements for deformed and plain steel reinforcing bars with protective epoxy coating applied in accordance with Specification A 775/A 775M.

1.2 This specification is applicable for orders in either SI units (as Specification D 3963M) or inch-pound units (as Specification D 3963).

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the inch-pound units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

A775/A775M Specification for Epoxy-Coated Steel Reinforcing Bars

B117 Practice for Operating Salt Spray (Fog) Apparatus

D374 Test Methods for Thickness of Solid Electrical Insulation

D2967 Test Method for Corner Coverage of Powder Coatings

E177 Practice for Use of the Terms Precision and Bias in ASTM Test Methods

E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method

G20 Test Method for Chemical Resistance of Pipeline Coatings

Federal Highway Administration Report

Keywords

coating requirements; concrete reinforcement; corrosion resistance; epoxy coating; fabrication repair; field repair; steel bars; Chemical resistance; Chloride permeability; Concrete reinforcement specifications; Corrosion-resistant steel specifications; Edge coverage; Epoxy-coated steel bars specifications; Fabricated materials specifications; Field repair; Jobsite handling; Pavement surfaces specifications; Salt spray resistance; Steel bars (concrete reinforcement- specifications)

ICS Code

ICS Number Code 77.140.60 (Steel bars and rods)

Citing ASTM Standards

[Back to Top]