ASTM D3783

1.1 This performance specification covers woven flat lining fabrics composed of any textile fiber or mixture of textile fibers for men's and boys' apparel.

1.2 This performance specification is not applicable to woven pile, woven fusible, fire-bonded fusible, sliver-knit pile, and sheepskin lining fabrics.

1.3 These requirements apply to the length and width directions for those properties where fabric direction is pertinent.

1.4 The following safety hazards caveat pertains only to the test method described in this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents

Federal Standards
16 CFR Chapter II--Consumer Product Safety Commission, Subchapter D-Flammable Fabrics Act Regulations
ASTM Standards
D123 Terminology Relating to Textiles
D1336 Test Method for Distortion of Yarn in Woven Fabrics
D1424 Test Method for Tear Resistance of Woven Fabrics by Falling-Pendulum (Elmendorf) Apparatus
D2261 Test Method for Tearing Strength of Woven Fabrics by the Tongue (Single-Rip) Method (Constant-Rate-of-Extension Tensile Testing Machine)
D2262 Test Method for Tearing Strength of Woven Fabrics by the Tongue (Single Rip) Method (Constant-Rate-of-Traverse Tensile Testing Machine)
D2724 Test Methods for Bonded, Fused, and Laminated Apparel Fabrics
D2905 Practice for Statements on Number of Specimens for Textiles
D434 Test Method for Resistance to Slippage of Yarns in Woven Fabrics Using a Standard Seam
D5034 Test Method for Breaking Force and Elongation of Textile Fabrics (Grab Test)
Military Standard
MIL-STD-105D Sampling Procedures and Tables for Inspection by Attributes
AATCC Test Methods
EvaluationProcedure3 AATCC Chromatic Transference Scale

Index Terms

fabric; lining; performance; specification; Number Code 59.080.30 (Textile fabr)

Citing ASTM Standards

[Back to Top]