ASTM D3613-98

    Withdrawn Standard: ASTM D3613-98 Standard Practice for Sampling Insulating Liquids for Gas Analysis and Determination of Water Content (Withdrawn 2007)

    Developed by Subcommittee: D27.07

    WITHDRAWN, NO REPLACEMENT

    Buy Standard (PDF)
    3 pages
    $44.40


    Withdrawn Rationale:

    This practice covers sampling electrical insulating liquids having a viscosity less than 650 cSt at 40C from apparatus for analysis of their gas content or for measurement of water content, or both.

    Formerly under the jurisdiction of Committee D27 on Electrical Insulating Liquids and Gases and Subcommittee D27.07 on Physical Test, this practice was withdrawn in July 2007 because the standard has been incorporated into the revised Practices D 923 for Sampling Electrical Insulating Liquids.

    For referenced ASTM standards, visit the ASTM website, www.astm.org, or contact ASTM Customer Service at service@astm.org. For Annual Book of ASTM Standards volume information, refer to the standard's Document Summary page on the ASTM website.

    1. Scope

    1.1 This practice covers sampling electrical insulating liquids having a viscosity less than 650 cSt at 40oC from apparatus for analysis of their gas content or for measurement of water content, or both. Guide D117, Test Methods D1533, and Test Methods D3612 provide detailed information regarding gas and water testing. Definitions of terms used in this practice may be found in Terminology D2864.

    1.2 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 6 and 7.


    DOI: 10.1520/D3613-98

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top