This test method describes procedures to be used for sampling calcium chloride, and for determining grading of solid forms of calcium chloride for comparison with the requirements of a specification, such as Specification D98.

1. Scope

1.1 This test method covers sampling of solid and liquid forms of calcium chloride, and sieve analysis of solid form calcium chloride. Referee procedures for chemical analysis are covered in Test Methods E449.

1.2 A rapid method of chemical analysis is shown in Appendix X1. This rapid method is not to be used for determining chemical compliance of calcium chloride with specification requirements, such as in Specification D98.

1.3 The values stated in SI units are to be regarded as the standard.

1.4 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.1.1 This appendix covers a rapid method for chemical analysis of calcium chloride.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

Index Terms

calcium chloride; grading; sampling; sieve analysis; Calcium chloride; Grading; Sampling concrete/mortar/aggregates; Sieve analysis;

ICS Code

ICS Number Code 71.060.50 (Salts)

Citing ASTM Standards

[Back to Top]