Active Standard ASTM D3374 | Developed by Subcommittee: D13.18
Book of Standards Volume: 07.01
Historical (view previous versions of standard)
This specification covers vinyl-coated glass yarns. These yarns are manufactured in two basic classes. These classes have been established that when properly woven into screening, satisfactory strength, durability, and insect protection are obtained. The two classes are as follows: Class 1 and Class 2. The yarn shall be glass continuous filament glass yarn which meets the requirements specified. The material used to coat or impregnate the glass continuous filament yarn shall be a compound of polymerized or copolymerized vinyl chloride resin, plasticized with phosphate or phthalate ester plasticizers exclusively, pigmented and stabilized to meet the requirements specified. The following test methods shall be performed in accordance with specified requirements: yarn number, ignition loss, breaking force, and color stability to accelerated weathering.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1.1 This specification covers vinyl-coated glass yarns. These yarns are manufactured in two basic classes. These classes have been established that when properly woven into screening, satisfactory strength, durability, and insect protection are obtained. The two classes are as follows:
1.1.1 Class 1—Nominal thickness 0.292 mm (0.0115 in.).
1.1.2 Class 2—Nominal thickness 0.330 mm (0.0130 in.).
1.2 The values stated in either SI or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with this specification.
1.3 The following precautionary statement pertains only to the test method portions, Sections 12–21, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Federal StandardCCC-D-950 Specification, Dyeing and After Treating Processes for Cotton Cloths Available from General Services Administration, Specification and Consumer Information Distribution Section (WFSIS), Washington Navy Yard, Bldg. 197, Washington, DC 20407.
D123 Terminology Relating to Textiles
D578 Specification for Glass Fiber Strands
D1907 Test Method for Linear Density of Yarn (Yarn Number) by the Skein Method
D2256 Test Method for Tensile Properties of Yarns by the Single-Strand Method
D4963 Test Method for Ignition Loss of Glass Strands and Fabrics
D7018 Terminology Relating to Glass Fiber and Its Products
ANSI/ASQC StandardsANSI/ASQC Z1.9 Sampling Procedures and Tables for Inspection by Variables for Percent Nonconforming
AATCC StandardEvaluation Procedure Gray Scale for Color Change Available from American Association of Textile Chemists and Colorists, P.O. Box 12215, Research Triangle Park, NC 27709.
ICS Number Code 59.080.40 (Coated fabrics)
UNSPSC Code 11151714(Glass yarn)