Abstract
This specification covers unfilled, unpigmented FEP-fluorocarbon resin sheet and film. The sheet and film shall be made from FEP-fluorocarbon resin without filler or plasticizer. This specification allows for the use of recycled, reprocessed, and reworked FEP materials provided that: the final physical, mechanical, and performance requirements are met; and the toxicological characteristics are essentially unaltered from that of virgin material. The tensile strength, elongation at break, dimensional change on heating, cementability, dielectric strength, and density of the sheet and film shall be tested.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1. Scope
1.1 This specification covers unfilled, unpigmented FEP-fluorocarbon resin sheet and film less than 3.175 mm (0.125 in.) thick. Recycled materials are allowed in accordance with 6.2.
1.2 The values stated in SI units as detailed in are to be regarded as standard and the practices of incorporated herein.
1.3 The following safety hazards caveat pertains only to the test methods portion, Section 14, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 1—There is no known ISO equivalent to this standard.
2. Referenced Documents (purchase separately) 
The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D149 Test Method for Dielectric Breakdown Voltage and Dielectric Strength of Solid Electrical Insulating Materials at Commercial Power Frequencies
D374 Test Methods for Thickness of Solid Electrical Insulation
D618 Practice for Conditioning Plastics for Testing
D638 Test Method for Tensile Properties of Plastics
D792 Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement
D882 Test Method for Tensile Properties of Thin Plastic Sheeting
D883 Terminology Relating to Plastics
D2116 Specification for FEP-Fluorocarbon Molding and Extrusion Materials
D3892 Practice for Packaging/Packing of Plastics
D5740 Guide for Writing Material Standards in the Classification D 4000 Format
E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
Other Standard
TAPPI411 Standard Thickness (Caliper) of Paper and Paper Products
Keywords
FEP-fluorocarbon resin; film; fluoropolymer; recycled material; sheet; Cementability; Perfluoro(ethylene-propylene)(FEP) copolymer--specifications;
ICS Code
ICS Number Code 83.140.10 (Films and sheets)
DOI: 10.1520/D3368-04R10
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]
