Withdrawn Rationale:
This test method is intended for use on petroleum fuel oils, such as those covered in Specification D 396 Grade No 4(Light), 4, 5(Light), 5, and 6, or similar fuels.
This test method is being balloted for withdrawal with no replacement because the test method is no longer in use, and there is no report from the CS92 ILCP.
Formerly under the jurisdiction of Committee D02 on Petroleum Products and Lubricants, this test method was withdrawn in May 2010.
1. Scope
1.1 This test method is intended for use on petroleum fuel oils, such as those covered in Specification D 396 Grade No 4(Light), 4, 5(Light), 5, and 6, or similar fuels.
1.2 The values stated in SI units are to be regarded as standard. The values in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
handling point; industrial fuel; pumpability; storage point;
DOI: 10.1520/D3245-03
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]
