ASTM D3205-86(1991)

    Standard Test Method for Viscosity of Asphalt with Cone and Plate Viscometer (Withdrawn 2000)

    Withdrawn Standard: ASTM D3205-86(1991) | Developed by Subcommittee: D04.44

    WITHDRAWN, NO REPLACEMENT


    There is no PDF download available at this time, however you may purchase a copy of this document from the IHS Standards Store
    (Click here to view IHS phone and email contact details).



    1. Scope

    1.1 This test method covers the determination of the viscosity of asphalt cements by means of a cone-plate viscometer. It is applicable to materials having viscosities in the range from 10 to 10 P (10 to 10 Pa[dot]s) and is therefore suitable for use at temperatures where viscosity is in the range indicated. The shear rate may vary between approximately 10 to 10 s and the method is suitable for determination on materials having either Newtonian or non-Newtonian flow properties.

    1.2 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.



    Referencing This Standard

    DOI: 10.1520/D3205-86R91

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM D3205-86(1991), Standard Test Method for Viscosity of Asphalt with Cone and Plate Viscometer (Withdrawn 2000), ASTM International, West Conshohocken, PA, 1991, www.astm.org

    Back to Top