ASTM D3204-93(2003)

    Standard Specification for Preformed Cellular Plastic Joint Fillers for Relieving Pressure (Withdrawn 2004)

    Withdrawn Standard: ASTM D3204-93(2003) | Developed by Subcommittee: D04.34

    WITHDRAWN, NO REPLACEMENT


      Format Pages Price  
    PDF 2 $44.40   ADD TO CART


    Withdrawn Rationale:

    This specification covers preformed pressure-relief joint fillers of the following two types made from cellular plastic materials having suitable compressibility and nonextruding characteristics.

    Formerly under the jurisdiction of Committee D04 on Roads and Paving Materials, this specification was withdrawn in June 2004. This specification was withdrawn because the level of use and interest was either none or very minimal.

    1. Scope

    1.1 This specification covers preformed pressure-relief joint fillers of the following two types made from cellular plastic materials having suitable compressibility and nonextruding characteristics.

    1.1.1 Type I, closed cell polyethylene, and

    1.1.2 Type II, open cell polyurethane.

    1.2 These joint fillers are intended for use in concrete pavements in full-depth joints measuring approximately 4.0 in. (102 mm) in width to relieve stress or avoid potential distress in adjacent structures or pavements.

    1.3 The values stated in inch-pound units are to be regarded as the standard.



    DOI: 10.1520/D3204-93R03

    ASTM International is a member of CrossRef.