ASTM D3178-89(2002)

    Standard Test Methods for Carbon and Hydrogen in the Analysis Sample of Coal and Coke (Withdrawn 2007)

    Withdrawn Standard: ASTM D3178-89(2002) | Developed by Subcommittee: D05.21

    WITHDRAWN, REPLACED BY D5373


      Format Pages Price  
    PDF 5 $50.40   ADD TO CART

    Active (view current version of standard)

    ASTM License Agreement


    Withdrawn Rationale:

    These test methods cover the determination of total carbon and hydrogen in samples of coal or coke. Both the carbon and hydrogen are determined in one operation. These test methods yield the total percentages of carbon and hydrogen in the coal as analyzed and the results include not only the carbon and hydrogen in the organic matter, but also the carbon present in mineral carbonates and the hydrogen present in the free moisture accompanying the sample as well as hydrogen present as water of hydration of silicates.

    Formerly under the jurisdiction of Committee D05 on Coal and Coke, these test methods were withdrawn in June 2007 because there is no reproducibility statement for D 3178. These test methods were replaced by Practice D 5573 Classifying Failure Modes in Fiber-Reinforced-Plastic (FRP) Joints.

    For referenced ASTM standards, visit the ASTM website, www.astm.org, or contact ASTM Customer Service at service@astm.org. For Annual Book of ASTM Standards volume information, refer to the standard's Document Summary page on the ASTM website.

    1. Scope

    1.1 These test methods cover the determination of total carbon and hydrogen in samples of coal or coke. Both the carbon and hydrogen are determined in one operation. These test methods yield the total percentages of carbon and hydrogen in the coal as analyzed and the results include not only the carbon and hydrogen in the organic matter, but also the carbon present in mineral carbonates and the hydrogen present in the free moisture accompanying the sample as well as hydrogen present as water of hydration of silicates.

    Note 1—It is recognized that certain technical applications of the data derived from this test procedure may justify additional corrections. These corrections could involve compensation for the carbon present as carbonates, the hydrogen of free moisture accompanying the sample, and the calculated hydrogen present as water of hydration of silicates.

    1.2 When data are converted and reported on the "dry" basis, the hydrogen value is corrected for the hydrogen present in the free moisture accompanying the sample.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    1.4 The values stated in SI units are to be regarded as the standard.



    DOI: 10.1520/D3178

    ASTM International is a member of CrossRef.