ASTM D3164M-03

    Standard Test Method for Strength Properties of Adhesively Bonded Plastic Lap-Shear Sandwich Joints in Shear by Tension Loading (Withdrawn 2012)

    Withdrawn Standard: ASTM D3164M-03 | Developed by Subcommittee: D14.40

    WITHDRAWN, NO REPLACEMENT


      Format Pages Price  
    PDF 4 $45.60   ADD TO CART


    Withdrawn Rationale:

    This test method is intended to complement Test Method D1002 and Test Method D3163 and extend its application to single-lap-shear adhesive joints employing plastic adherends. The test method is useful for generating comparative shear strength data for joints made from a number of plastics. It can also provide a means by which several plastics surface treatments can be compared.

    Formerly under the jurisdiction of Committee D14 on Adhesives, this test method was withdrawn in January 2012 in accordance with section 10.5.3.1 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.

    1. Scope

    1.1 This test method is intended to complement Test Method D 1002 and D 3163 and extend its application to single-lap-shear adhesive joints employing plastic adherends. The test method is useful for generating comparative shear strength data for joints made from a number of plastics. It can also provide a means by which several plastics surface treatments can be compared.

    1.2 The values stated in SI units are to be regarded as the standard.

    Note 1—A soft metric (conversion from English) companion to Test Method D 3164M has been developed - D 3164.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.



    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D907 Terminology of Adhesives

    D1002 Test Method for Apparent Shear Strength of Single-Lap-Joint Adhesively Bonded Metal Specimens by Tension Loading (Metal-to-Metal)

    D2093 Practice for Preparation of Surfaces of Plastics Prior to Adhesive Bonding

    D2651 Guide for Preparation of Metal Surfaces for Adhesive Bonding

    D3163 Test Method for Determining Strength of Adhesively Bonded Rigid Plastic Lap-Shear Joints in Shear by Tension Loading

    D3164 Test Method for Strength Properties of Adhesively Bonded Plastic Lap-Shear Sandwich Joints in Shear by Tension Loading

    D4896 Guide for Use of Adhesive-Bonded Single Lap-Joint Specimen Test Results

    E4 Practices for Force Verification of Testing Machines


    Referencing This Standard

    DOI: 10.1520/D3164M-03

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM D3164M-03, Standard Test Method for Strength Properties of Adhesively Bonded Plastic Lap-Shear Sandwich Joints in Shear by Tension Loading (Withdrawn 2012), ASTM International, West Conshohocken, PA, 2012, www.astm.org

    Back to Top