WITHDRAWN, NO REPLACEMENT
| ||Format||Pages||Price|| |
|2||$46.80||  ADD TO CART|
This test method covers the determination of free maleic acid in refined maleic anhydride by potentiometric titration.
Formerly under the jurisdiction of Committee D16 on Aromatic Hydrocarbons and Related Chemicals, this test method was withdrawn in January 2012 in accordance with section 10.5.3.1 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.
1.1 This test method covers the determination of free maleic acid in refined maleic anhydride by potentiometric titration.
1.2 This test method is applicable for all concentrations of maleic acid; however, it is primarily used for concentrations below 0.5 %.
1.3 The following applies to all specified limits in this standard: For purposes of determining conformance with this standard, an observed value or a calculated value shall be rounded off "to the nearest unit" in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E 29.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 7.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D1193 Specification for Reagent Water
D3438 Practice for Sampling and Handling Naphthalene, Maleic Anhydride, and Phthalic Anhydride
E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
Other DocumentsOSHA Regulations, 29 CFR, paragraphs 1910.1000 and 1910.1200.
ASTM D2930-03, Standard Test Method for Maleic Acid in Maleic Anhydride by Potentiometric Titration (Withdrawn 2012), ASTM International, West Conshohocken, PA, 2003, www.astm.orgBack to Top