ASTM D2823 / D2823M - 05(2011)e1

    Standard Specification for Asphalt Roof Coatings, Asbestos Containing

    Active Standard ASTM D2823 / D2823M | Developed by Subcommittee: D08.05

    Book of Standards Volume: 04.04


    Buy Standard (PDF)
    2 pages
    $37.00
    Buy Standard (Print)
    2 pages
    $37.00
    Buy Standard + Redline (PDF)
    4 pages
    $44.40

    Historical (view previous versions of standard)


    ASTM D2823 / D2823M

    Abstract

    This specification covers two types of asbestos-containing asphalt roof coatings consisting of an asphalt base, volatile petroleum solvents, and mineral stabilizers including asbestos fiber, mixed to a smooth, uniform consistency suitable for application by squeegee, three-knot brush, paint brush, roller, or by spraying. Type I is made from asphalts characterized as self-healing, adhesive, and ductile, while Type II is made from asphalts characterized by high softening point and relatively low ductility. The coatings shall comply with specified composition limits of water, nonvolatile matter, asbestos and other mineral stabilizers, asphalt, and mineral matter based on original mass of insoluble residue. They shall also adhere to physical requirements as to uniformity, consistency, and pliability and behavior at given temperatures.

    This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

    1. Scope

    1.1 This specification covers asbestos-containing asphalt roof coatings of brushing or spraying consistency.

    1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D312 Specification for Asphalt Used in Roofing

    D449 Specification for Asphalt Used in Dampproofing and Waterproofing

    D946 Specification for Penetration-Graded Asphalt Cement for Use in Pavement Construction

    D1079 Terminology Relating to Roofing and Waterproofing

    D6511 Test Methods for Solvent Bearing Bituminous Compounds


    ICS Code

    ICS Number Code 91.100.50 (Binders. Sealing materials)

    UNSPSC Code

    UNSPSC Code 30121601(Asphalt); 11101510(Asbestos)


    DOI: 10.1520/D2823_D2823M-05R11E01

    ASTM International is a member of CrossRef.

    ASTM D2823 / D2823M

    Citing ASTM Standards
    Back to Top