This specification covers the materials commercially known as gold bronze, pale gold bronze, and rich gold bronze powders. The gold bronze powder shall be made from new ingot metals, shall consist of fine polished flakes containing the prescribed percentage of fatty or oily matter (polishing lubricant), shall have the specified residue content and leafing properties, and shall be suitable for making gold bronze paint. The sampling and test methods to determine conformance to the specified composition and properties are given.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1.1 This specification covers the materials commercially known as gold bronze, pale gold bronze, and rich gold bronze powders.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D13 Specification for Spirits of Turpentine
D185 Test Methods for Coarse Particles in Pigments
D480 Test Methods for Sampling and Testing of Flaked Aluminum Powders and Pastes
U.S. Federal Specification
A-A-1800 Water-Resisting Spar Varnish Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098, http://www.dodssp.daps.mil.
bronze powders; leafing; spar varnish; Paint pigments--specifications; Bronze powders; Gold bronze powder; Leafing pigment; Spar varnish;
ICS Number Code 87.060.99 (Other paint ingredients)
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]