WITHDRAWN, NO REPLACEMENT
| ||Format||Pages||Price|| |
|4||$46.80||  ADD TO CART|
p>These test methods cover procedures for testing flexible materials consisting of two or more insulating components combined to form a composite to be used as an electrical insulation.
Formerly under the jurisdiction of Committee D09 on Electrical and Electronic Insulating Materials, these test methods were withdrawn in September 2005. These test methods were withdrawn without replacement since Committee D09 cannot maintain a standard for which the expertise may not lie within the current committee membership, or for which the utilization of the standard is questionable.
1.1 These test methods cover procedures for testing flexible materials consisting of two or more insulating components combined to form a composite to be used as an electrical insulation.
1.2 The procedures appear in the following order:ASTM Reference Procedure Section Method Breaking Strength 25 to 31 D 202,
1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.> A specific warning statement is given in 13.2.
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM D2381-87(1999)e1, Standard Test Methods for Flexible Composite Materials Used for Electrical Insulation (Withdrawn 2005), ASTM International, West Conshohocken, PA, 1999, www.astm.orgBack to Top