Standard Active Last Updated: Oct 07, 2021 Track Document
ASTM D2347-00(2021)

Standard Test Method for Measuring Area of Leather Test Specimens

Standard Test Method for Measuring Area of Leather Test Specimens D2347-00R21 ASTM|D2347-00R21|en-US Standard Test Method for Measuring Area of Leather Test Specimens Standard new BOS Vol. 15.04 Committee D31
$ 55.00 In stock

Significance and Use

4.1 This test method is designed to measure the area of specimens before and after they are subjected to various tests that may effect surface area. Two test procedures wherein such measurements could be used are for the apparent density of leather and the resistance of leather to synthetic perspiration solution.

Scope

1.1 This test method covers the measurement of the surface area of leather test specimens. Unless otherwise specified, the surface to be measured shall be the grain surface or the surface most closely adjacent to the grain surface. This test method does not apply to wet blue.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 15.04
Developed by Subcommittee: D31.07
Pages: 2
DOI: 10.1520/D2347-00R21
ICS Code: 59.140.30