ASTM D2271-94(1999)e1

    Standard Test Method for Preliminary Examination of Hydraulic Fluids (Wear Test) (Withdrawn 2004)

    Withdrawn Standard: ASTM D2271-94(1999)e1 | Developed by Subcommittee: D02.N0.07

    WITHDRAWN, NO REPLACEMENT


      Format Pages Price  
    PDF 5 $51.60   ADD TO CART


    Withdrawn Rationale:

    This test method covers a constant volume high-pressure vane pump test procedure for indicating the wear preventative characteristics of petroleum and non-petroleum hydraulic fluids.

    Formerly under the jurisdiction of Committee D02 on Petroleum Products and Lubricants, this test method was withdrawn in May 2004 because the industry cannot run the method as currently written due to lack of approved hardware.

    1. Scope

    1.1 This test method covers a constant volume high-pressure vane pump test procedure for indicating the wear preventative characteristics of petroleum and non-petroleum hydraulic fluids.

    1.2 The values stated in either acceptable metric units or in other units shall be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining values in any way.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Notes 5, 11, and 21.



    Referencing This Standard

    DOI: 10.1520/D2271-94R99E01

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM D2271-94(1999)e1, Standard Test Method for Preliminary Examination of Hydraulic Fluids (Wear Test) (Withdrawn 2004), ASTM International, West Conshohocken, PA, 2000, www.astm.org

    Back to Top