These test methods may be used to confirm the stated lead oxide, chromium trioxide and silica content of basic lead silicochromate and is useful for quality control.

1. Scope

1.1 These test methods cover the chemical analysis of the pigment commercially known as basic lead silicochromate and are applicable to pigment supplied by the manufacturer and to pigment, but not mixed pigments, separated from liquid coatings. The presence of basic lead silicochromate species shall be confirmed by X-ray diffraction analysis (see Specification D 1648).

1.2 For liquid coatings the pigment must first be separated from the vehicle before conducting the analysis.

1.3 The analytical procedures appear in the following order:

1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.5 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

Keywords

basic lead silicochromate; chromium in basic lead silicochromate; lead in basic lead silicochromate; lead oxide; pigment; silica in basic lead silicochromate; Anti-corrosion pigments--basic lead silicochromate; Basic lead silicochromate; Chromium trioxide content; Lead screening testing; Silica content;

ICS Code

ICS Number Code 87.060.10 (Pigments and extenders)

Citing ASTM Standards

[Back to Top]