ASTM D1825-03

    Standard Practice for Etching and Cleaning Copper-Clad Electrical Insulating Materials and Thermosetting Laminates for Electrical Testing (Withdrawn 2012)

    Withdrawn Standard: ASTM D1825-03 | Developed by Subcommittee: D09.07

    WITHDRAWN, NO REPLACEMENT


      Format Pages Price  
    PDF Version 2 $44.40   ADD TO CART


    Withdrawn Rationale:

    This practice describes a procedure for etching and cleaning copper-clad electrical insulating materials and thermosetting laminates for electrical testing.

    Formerly under the jurisdiction of Committee D09 on Electrical Insulation, this standard was withdrawn in January 2012 in accordance with section 10.5.3.1 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.

    1. Scope

    1.1 This practice describes a procedure for etching and cleaning copper-clad electrical insulating materials and thermosetting laminates for electrical testing.

    1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific warning statements see 6.3 and 6.4.



    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D1867 Specification for Copper-Clad Thermosetting Laminates for Printed Wiring


    DOI: 10.1520/D1825-03

    ASTM International is a member of CrossRef.