ASTM D1775-94

    Standard Test Method for Tension and Elongation of Wide Elastic Fabrics (Constant-Rate-of-Load Type Tensile Testing Machine) (Withdrawn 2000)

    Withdrawn Standard: ASTM D1775-94 | Developed by Subcommittee: D13.24

    WITHDRAWN, NO REPLACEMENT


    There is no PDF download available at this time, however you may purchase a copy of this document from the IHS Standards Store
    (Click here to view IHS phone and email contact details).



    1. Scope

    1.1 This test method covers the measurement of tension and elongation characteristics of wide elastic fabrics made from natural or man-made elastomers, either alone or in combination with other textile yarns, when tested with a constant-rate-of-loading (CRL) type tensile testing machine.

    Note 1-For determination of similar testing using the constant-rate-of-extension (CRL) type tensile testing machine, refer to Test Method D4964.

    1.1.1 This test method is not applicable to narrow elastic fabrics.

    1.2 The use of this test method requires the selection of, or mutual agreement upon, tension(s) and elongation(s) at which the test results will be determined.

    1.3 In testing laundered elastic fabrics, the laundering procedures require mutual agreement on the selection of temperature and number of washing cycles and drying cycles to be used.

    1.4 The values stated in SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore each system must be used independently of the other, without combining values in any way.

    1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.



    DOI: 10.1520/D1775-94

    ASTM International is a member of CrossRef.