This test method differentiates the relative corrosion-preventive capabilities of lubricating greases under the conditions of the test.

1. Scope

1.1 This test method covers the determination of the corrosion preventive properties of greases using grease-lubricated tapered roller bearings stored under wet conditions. This test method is based on CRC Technique L 41 that shows correlations between laboratory results and service for grease lubricated aircraft wheel bearings.

1.2 Apparatus Dimensions—The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

1.3 All Other Values—The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

Keywords

bearing; corrosion; lubricating grease; rust

ICS Code

Citing ASTM Standards

[Back to Top]