Withdrawn Rationale:
This test method covers evaluation of the abrasive properties of graphites that are used for lubricating purposes.
Formerly under the jurisdiction of Committee D02 on Petroleum Products and Lubricants, this test method was withdrawn in October 2006.
This standard is being withdrawn without replacement due to its lack of use in the industry.
1. Scope
1.1 This test method covers evaluation of the abrasive properties of graphites that are used for lubricating purposes.
1.2 The values stated in SI units are to be regarded as the standard. The values stated in parentheses are for information only.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
ball bearing; graphite; relative abrasiveness;
DOI: 10.1520/D1367-96R01E01
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]
