ASTM D1330 - 04(2010)

    Standard Specification for Rubber Sheet Gaskets

    Active Standard ASTM D1330 | Developed by Subcommittee: D11.37

    Book of Standards Volume: 09.02


    Buy Standard (PDF)
    2 pages
    $37.00
    Buy Standard (Print)
    2 pages
    $37.00

    Historical (view previous versions of standard)


    ASTM D1330

    Abstract

    This specification covers gaskets cut from sheet rubber that are intended for general gasket applications on water, air, and low-pressure steam. The rubber sheet gasket covered by this specification are not intended for use with oils and strong acids. Compounds furnished under this specification shall be manufactured from natural rubber, reclaimed rubber, synthetic rubber, or mixtures thereof, together with added compounding materials, and shall be suitably vulcanized. The material shall be red or black in color as specified and shall conform to the prescribed physical property requirements including hardness, tensile strength, elongation, change in tensile strength and elongation after air aging, and compression set. Hardness, tensile strength, compression set, and air-aging tests shall be performed.

    This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

    1. Scope

    1.1 This specification covers gaskets cut from sheet rubber that are intended for general gasket applications on water, air, and low-pressure steam. They are not intended for use with oils and strong acids.

    1.2 The values stated in SI units are to be regarded as the standard.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D395 Test Methods for Rubber Property--Compression Set

    D412 Test Methods for Vulcanized Rubber and Thermoplastic Elastomers--Tension

    D573 Test Method for Rubber--Deterioration in an Air Oven

    D865 Test Method for Rubber--Deterioration by Heating in Air (Test Tube Enclosure)

    D1415 Test Method for Rubber Property--International Hardness

    D2240 Test Method for Rubber Property--Durometer Hardness

    D3182 Practice for Rubber--Materials, Equipment, and Procedures for Mixing Standard Compounds and Preparing Standard Vulcanized Sheets

    D3183 Practice for Rubber--Preparation of Pieces for Test Purposes from Products


    ICS Code

    ICS Number Code 21.140 (Seals, glands)

    UNSPSC Code

    UNSPSC Code 31400000(Gaskets)


    DOI: 10.1520/D1330-04R10

    ASTM International is a member of CrossRef.

    ASTM D1330

    Citing ASTM Standards
    Back to Top