This test method is useful in indicating the differences in modulus of rupture between the various dimension stones. This test method also provides one element in comparing stones of the same type.

1. Scope

1.1 This test method covers the determination of the modulus of rupture of all types of dimension stone except slate.

1.2 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

C119 Terminology Relating to Dimension Stone

Keywords

dimension stone; flexure; modulus of rupture; stone; test; Compression testing--rock/related materials; Dimension stone; Loading tests--rock/related materials; Modulus of rupture (MOR);

ICS Code

ICS Number Code 91.100.15 (Mineral materials and products)

Citing ASTM Standards

[Back to Top]