ASTM C811-98(2008)

Withdrawn Rationale:

This practice provides for the preparation of concrete to receive resinous monolithic surfacings. In these recommendations, the term monolithic surfacings includes toppings applied 60 mils (1.5 mm) in thickness or greater over concrete, which cure in place, are continuously bonded to the concrete surface, and provide a continuous surfacing.

Formerly under the jurisdiction of Committee C03 on Chemical-Resistant Nonmetallic Materials, this practice was withdrawn in August 2012 because it is not currently being used by the industry.

1.1 This practice provides for the preparation of concrete to receive resinous monolithic surfacings. In these recommendations, the term monolithic surfacings includes toppings applied 60 mils (1.5 mm) in thickness or greater over concrete, which cure in place, are continuously bonded to the concrete surface, and provide a continuous surfacing.

1.2 The surfacings consist of fillers, resins, and hardeners which when properly mixed, applied and cured, bond to primed or unprimed concrete. The monolithic surfacings may be either reinforced or unreinforced.

1.3 This practice does not restrict the method of application.

1.4 This practice is intended for use with filled resin systems such as those covered by Specification C 722 and is not intended to supersede specific manufacturer's instructions.

1.5 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

C722 Specification for Chemical-Resistant Monolithic Floor Surfacings

C904 Terminology Relating to Chemical-Resistant Nonmetallic Materials

D4258 Practice for Surface Cleaning Concrete for Coating

D4259 Practice for Abrading Concrete

D4260 Practice for Liquid and Gelled Acid Etching of Concrete

D4262 Test Method for pH of Chemically Cleaned or Etched Concrete Surfaces

D4263 Test Method for Indicating Moisture in Concrete by the Plastic Sheet Method

D4285 Test Method for Indicating Oil or Water in Compressed Air

Other Standards

Keywords

chemical-resistant monolithic surfacings; surface preparation; Chemical-resistant monolithic surfacings; Concrete; Resins (monolithic surfacings); Specimen preparation (general); Surface preparation;

Citing ASTM Standards

[Back to Top]