You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    ASTM C559 - 16

    Standard Test Method for Bulk Density by Physical Measurements of Manufactured Carbon and Graphite Articles

    Active Standard ASTM C559 | Developed by Subcommittee: D02.F0

    Book of Standards Volume: 05.05


      Format Pages Price  
    PDF 3 $39.00   ADD TO CART
    Hardcopy (shipping and handling) 3 $39.00   ADD TO CART
    Standard + Redline PDF Bundle 6 $46.80   ADD TO CART


    Significance and Use

    4.1 Bulk density as determined by this test method is a basic material property of importance in manufacturing and application of carbon and graphite.

    4.2 This test method can be used for quality and process control, material characterization and description, and other purposes.

    1. Scope

    1.1 This test method covers the determination of the bulk density of manufactured articles of carbon and graphite of at least 500 mm3 volume. The bulk density is calculated to an accuracy of 0.25 %, using measurements of mass and dimensions in air at 25 °C ± 5 °C.

    1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    ICS Code

    ICS Number Code 71.100.99 (Other products of the chemical industry)

    UNSPSC Code

    UNSPSC Code


    Referencing This Standard

    DOI: 10.1520/C0559-16

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM C559-16, Standard Test Method for Bulk Density by Physical Measurements of Manufactured Carbon and Graphite Articles, ASTM International, West Conshohocken, PA, 2016, www.astm.org

    Back to Top