ASTM C34 - 13

    Standard Specification for Structural Clay Load-Bearing Wall Tile

    Active Standard ASTM C34 | Developed by Subcommittee: C15.02

    Book of Standards Volume: 04.05


      Format Pages Price  
    PDF 3 $38.00   ADD TO CART
    Hardcopy (shipping and handling) 3 $38.00   ADD TO CART
    Standard + Redline PDF Bundle 6 $45.60   ADD TO CART


    Abstract

    This specification covers structural clay loading-bearing wall tiles of the following grades: Grade LBX, suitable for general use in masonry construction and adapted for use in masonry exposed to weathering; and Grade LB, suitable for general use in masonry where not exposed to frost action, or for use in exposed masonry where protected with a facing of stone, brick, terra cotta, or other masonry. Tile covered by this specification are manufactured from clay, shale, or similar naturally occurring substances and subjected to heat treatment at elevated temperatures (firing), which must develop sufficient fired bond between the particulate constituents to provide the strength and durability requirements. Tiles shall adhere to water absorption, compressive strength, and dimensional (nominal thickness and mass) requirements specified for individual grades.

    This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

    1. Scope

    1.1 This specification covers structural clay load-bearing wall tile.

    1.2 The property requirements of this specification apply at the time of purchase. The use of results from testing of tile extracted from masonry structures for determining conformance or non-conformance to the property requirements (Section 5) of this standard is beyond the scope of this specification.

    1.3 Tile covered by this specification are manufactured from clay, shale, or similar naturally occurring substances and subjected to a heat treatment at elevated temperatures (firing). The heat treatment must develop sufficient fired bond between the particulate constituents to provide the strength and durability requirements of this specification. (See firing and fired bond in Terminology C1232.)

    1.4 The text of this specification references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.

    1.5 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    C67 Test Methods for Sampling and Testing Brick and Structural Clay Tile

    C216 Specification for Facing Brick (Solid Masonry Units Made from Clay or Shale)

    C1232 Terminology of Masonry


    ICS Code

    ICS Number Code 81.080 (Refractories)

    UNSPSC Code

    UNSPSC Code 30131700(Tiles and flagstones)


    Referencing This Standard

    DOI: 10.1520/C0034

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM C34-13, Standard Specification for Structural Clay Load-Bearing Wall Tile, ASTM International, West Conshohocken, PA, 2013, www.astm.org

    Back to Top