| ||Format||Pages||Price|| |
|5||$44.00||  ADD TO CART|
|Hardcopy (shipping and handling)||5||$44.00||  ADD TO CART|
This specification covers the standard for non-asbestos fiber-cement perforated and plain pipe proposed for use in the conveyance of drainage water for the subsurface drainage of highways, airports, farms, foundations, and other similar drainage work. The pipes shall be composed of a mixture of inorganic hydraulic binder or a calcium silicate binder formed by the chemical reaction of siliceous material and a calcareous material reinforced by organic or inorganic fibers. The material shall be cured and formed under pressure and shall be of laminar construction. The material shall also comply with the minimum specified crushing strength.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1.1 This specification covers non-asbestos fiber-cement perforated and plain pipe intended for use in the conveyance of drainage water for the subsurface drainage of highways, airports, farms, foundations, and other similar drainage work.
1.2 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
C150 Specification for Portland Cement
C497 Test Methods for Concrete Pipe, Manhole Sections, or Tile
C500 Test Methods for Asbestos-Cement Pipe
C595 Specification for Blended Hydraulic Cements
C1154 Terminology for Non-Asbestos Fiber-Reinforced Cement Products
Federal StandardNo. 123 Marking for Domestic Shipment (Civilian Agencies) Available from Standardization Documents Order Desk, Bldg. 4 Section D, 700 Robbins Ave., Philadelphia, PA 19111-5094, Attn: NPODS.
Military StandardMIL-STD-129 Marking for Shipment and Storage
Other StandardsNational Motor Freight Classification Rules Availa Uniform Freight Classification Rules Available fr
ISO StandardsISO 2859 1999 Sampling Procedures for Inspection by Attributes Part 1: Sampling Schemes Indexed by Acceptance Quality Limit (AQL) for Lot-by-Lot Inspection ISO 390 1993 Products in Fibre Reinforced Cement-- Sampling and Inspection ISO 3951 1989 Sampling Procedures and Charts for Inspection by Variables for Percent Nonconforming
ICS Number Code 23.040.50 (Pipes and fittings of other materials)
UNSPSC Code 30111600(Cement and lime)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM C1447 / C1447M-04(2014), Standard Specification for Non-Asbestos Fiber-Cement Underdrain Pipe, ASTM International, West Conshohocken, PA, 2014, www.astm.orgBack to Top