You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    ASTM C1404/C1404M-98(2003)

    Standard Test Method for Bond Strength of Adhesive Systems Used with Concrete as Measured by Direct Tension (Withdrawn 2010)

    Withdrawn Standard: ASTM C1404/C1404M-98(2003) | Developed by Subcommittee: C09.25

    WITHDRAWN, NO REPLACEMENT


      Format Pages Price  
    PDF 5 $52.80   ADD TO CART


    Withdrawn Rationale:

    This test method covers the laboratory determination of the bond strength of adhesive systems used to adhere freshly mixed mortar to hardened portland-cement concrete.

    Formerly under the jurisdiction of Committee C09 on Concrete and Concrete Aggregates, this test method was withdrawn without replacement in December 2010 because of limited use by the industry.

    1. Scope

    1.1 This test method covers the laboratory determination of the bond strength of adhesive systems used to adhere freshly mixed mortar to hardened portland-cement concrete.

    1.2 The values stated, in either SI units or other units shall be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore each system must be used independently of the other, without combining values in any way.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.



    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A333/A333M Specification for Seamless and Welded Steel Pipe for Low-Temperature Service

    C33 Specification for Concrete Aggregates

    C39 Test Method for Compressive Strength of Cylindrical Concrete Specimens

    C42 Test Method for Obtaining and Testing Drilled Cores and Sawed Beams of Concrete

    C109 Test Method for Compressive Strength of Hydraulic Cement Mortars using 2-in. [50 mm] Cube Specimens

    C150 Specification for Portland Cement

    C171 Specification for Sheet Materials for Curing Concrete

    C192 Practice for Making and Curing Concrete Specimens in the Laboratory

    C305 Practice for Mechanical Mixing of Hydraulic Cement Pastes and Mortars of Plastic Consistency

    C494 Specification for Chemical Admixtures for Concrete

    C670 Practice for Preparing Precision Statements for Test Methods for Construction Materials

    C881 Specification for Epoxy-Resin-Base Bonding Systems for Concrete


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/C1404_C1404M-98R03

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM C1404 / C1404M-98(2003), Standard Test Method for Bond Strength of Adhesive Systems Used with Concrete as Measured by Direct Tension (Withdrawn 2010), ASTM International, West Conshohocken, PA, 1998, www.astm.org

    Back to Top