ASTM C1367 - 06(2012)

    Standard Test Method for Dead Load Resistance of a Sealant in Elevated Temperatures

    Active Standard ASTM C1367 | Developed by Subcommittee: C24.30

    Book of Standards Volume: 04.07


      Format Pages Price  
    PDF 4 $38.00   ADD TO CART
    Hardcopy (shipping and handling) 4 $38.00   ADD TO CART


    Significance and Use

    Sealants are generally subjected to stresses in end-use applications. This test method measures the heat resistance of sealants when subjected to dead load shear stresses while under heat.

    1. Scope

    1.1 This test method covers a laboratory procedure for determining the heat resistance of sealants. This test method is conducted under dead load in a shear mode. This test method was previously written to include only hot applied sealants.

    1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are provided for information purposes only.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    1.4 The subcommittee with jurisdiction of this standard is not aware of any similar or equivalent ISO standard.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B209 Specification for Aluminum and Aluminum-Alloy Sheet and Plate

    C717 Terminology of Building Seals and Sealants

    C1036 Specification for Flat Glass

    C1375 Guide for Substrates Used in Testing Building Seals and Sealants


    ICS Code

    ICS Number Code 83.140.50 (Seals)

    UNSPSC Code

    UNSPSC Code


    Referencing This Standard

    DOI: 10.1520/C1367-06R12

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM C1367-06(2012), Standard Test Method for Dead Load Resistance of a Sealant in Elevated Temperatures, ASTM International, West Conshohocken, PA, 2012, www.astm.org

    Back to Top