WITHDRAWN, NO REPLACEMENT
| ||Format||Pages||Price|| |
|3||$46.80||  ADD TO CART|
This test method covered the determination of the particle size distribution of advanced ceramic powders, specifically silicon nitride and carbides, in the range of 0.1 to 20 μm, having a median particle diameter from 0.5 to 5.0 μm.
Formerly under the jurisdiction of Committee C28 on Advanced Ceramics, this test method was withdrawn in January 2014. This standard has been withdrawn without replacement because the described technology/instrumentation (centrifugal particle size distribution analyzer) is no longer available and has been replaced during the last decade by more advanced technologies for determining particle size distributions of advanced ceramics.
1.1 This test method covers determination of the particle size distribution of advanced ceramic powders specifically silicon nitride and carbides, in the range of 0.1 to 20 μm, having a median particle diameter from 0.5 to 5.0 μm.
1.2 The procedure described in this test method may be applied successfully to other ceramic powders in this general size range, provided that appropriate dispersion procedures are developed. It is the responsibility of the user to determine the applicability of this test method to other materials.
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
C242 Terminology of Ceramic Whitewares and Related Products
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM C1282-08, Standard Test Method for Determining the Particle Size Distribution of Advanced Ceramics by Centrifugal Photosedimentation (Withdrawn 2014), ASTM International, West Conshohocken, PA, 2008, www.astm.orgBack to Top