ASTM C1053 - 00(2010)

    Standard Specification for Borosilicate Glass Pipe and Fittings for Drain, Waste, and Vent (DWV) Applications

    Active Standard ASTM C1053 | Developed by Subcommittee: C14.05

    Book of Standards Volume: 15.02


    Buy Standard (PDF)
    18 pages
    $48.00
    Buy Standard (Print)
    18 pages
    $48.00

    Historical (view previous versions of standard)


    ASTM C1053

    Abstract

    This specification covers chemically resistant, low expansion, Type I, borosilicate glass, Class A, used to manufacture corrosion-resistant pipe and fittings for drain, waste, and vent service. The pipe and fittings covered by the specification are intended for chemical resistant service above and below grade under gravity flow or vacuum conditions. The pipe and fittings shall have beaded or plain ends. The chemical and physical requirements shall conform to the requirements specified.

    This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

    1. Scope

    1.1 This specification covers chemically resistant, low expansion, Type I, borosilicate glass, Class A (see Specification E438), used to manufacture corrosion-resistant pipe and fittings for drain, waste, and vent service.

    1.2 The pipe and fittings covered by the specification are intended for chemical resistant service above and below grade under gravity flow or vacuum conditions.

    1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    1.4 The pipe and fittings shall have beaded or plain ends.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    C600 Test Method of Thermal Shock Test on Glass Pipe

    C623 Test Method for Youngs Modulus, Shear Modulus, and Poissons Ratio for Glass and Glass-Ceramics by Resonance

    C693 Test Method for Density of Glass by Buoyancy

    E438 Specification for Glasses in Laboratory Apparatus


    ICS Code

    ICS Number Code 23.040.50 (Pipes and fittings of other materials)

    UNSPSC Code

    UNSPSC Code


    DOI: 10.1520/C1053-00R10

    ASTM International is a member of CrossRef.

    ASTM C1053

    Citing ASTM Standards
    Back to Top