Active Standard ASTM B932 | Developed by Subcommittee: B02.07
Book of Standards Volume: 02.04
Historical (view previous versions of standard)
This specification discusses cover plate, sheet, and strip of low-carbon nickel-chromium-molybdenum-gadolinium alloy for use for neutron adsorption, structural, and corrosive application in nuclear waste disposal service. The specimen must be composed of the following elements: molybdenum, chromium, iron, cobalt, carbon, silicon, manganese, phosphorus, sulfur, nickel, oxygen, nitrogen, and gadolinium. Each plate, sheet, or strip shall be marked on one face with the specification number, alloy, heat number, manufacturers identification, and size. The markings shall have no deleterious effect on the material or its performance and shall be sufficiently stable to withstand normal handling. Each bundle or shipping container shall be marked with the name of the material; this specification number, alloy; the size; gross, tare, and net weight; consignor and consignee address; contract or order number, and such other information as may be defined in the contract or order.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1.1 This specification covers plate, sheet, and strip of low-carbon nickel-chromium-molybdenum-gadolinium alloy (UNS N06464) as shown in Table 1, for use for neutron adsorption, structural, and corrosive application in nuclear waste disposal service.
1.2 The following products are covered under this specification:
1.2.1 Sheet and Strip—Hot or cold rolled, solution annealed, and descaled unless solution anneal is performed in an atmosphere yielding a bright finish.
1.2.2 Plate—Hot or cold rolled, solution annealed, and descaled.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet (MSDS) for this product/material, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B906 Specification for General Requirements for Flat-Rolled Nickel and Nickel Alloys Plate, Sheet, and Strip
E112 Test Methods for Determining Average Grain Size
E140 Hardness Conversion Tables for Metals Relationship Among Brinell Hardness, Vickers Hardness, Rockwell Hardness, Superficial Hardness, Knoop Hardness, and Scleroscope Hardness
ICS Number Code 77.140.50 (Flat steel products and semi-products)
UNSPSC Code 11101706(Nickel)