ASTM B814 - 06(2011)

    Standard Specification for Nickel-Chromium-Iron-Molybdenum-Tungsten Alloy (UNS N06920) Plate, Sheet, and Strip

    Active Standard ASTM B814 | Developed by Subcommittee: B02.07

    Book of Standards Volume: 02.04


      Format Pages Price  
    PDF 3 $38.00   ADD TO CART
    Hardcopy (shipping and handling) 3 $38.00   ADD TO CART


    Abstract

    This specification covers the requirements for UNS N06920 nickel-chromium-iron-molybdenum-tungsten alloy in the form of rolled plates, sheets and strips for general corrosion service. The range of products covered here includes brightly finished hot or cold rolled, annealed and descaled unless solution-annealed sheets and strips and hot rolled, solution-annealed, and descaled plates.

    This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

    1. Scope

    1.1 This specification covers nickel-chromium-iron-molybdenum-tungsten alloy UNS N06920 in the form of rolled plate, sheet, and strip for general corrosion service.

    1.2 The following products are covered under this specification:

    1.2.1 Sheet and StripHot or cold rolled, annealed and descaled unless solution-annealing is performed in an atmosphere yielding a bright finish; and

    1.2.2 PlateHot rolled, solution-annealed, and descaled.

    1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard..

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet (MSDS) for this product/material as provided by the manufacturer, to establish appropriate safety and heal practices, and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B906 Specification for General Requirements for Flat-Rolled Nickel and Nickel Alloys Plate, Sheet, and Strip


    UNSPSC Code

    UNSPSC Code 11101711(Non ferrous alloy)


    Referencing This Standard

    DOI: 10.1520/B0814-06R11

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM B814-06(2011), Standard Specification for Nickel-Chromium-Iron-Molybdenum-Tungsten Alloy (UNS N06920) Plate, Sheet, and Strip, ASTM International, West Conshohocken, PA, 2011, www.astm.org

    Back to Top