This specification covers annealed UNS N06110 alloy welded pipes for general corrosion applications. Each pipe should be made from the flat-rolled alloy by an automatic welding process without any filler metal additions. Either only the weld metal or both weld and base metals should be cold worked after welding and prior to final annealing. The piped should also be furnished and the oxide removed. Descaling is not necessary when bright annealing is used.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 This specification covers welded UNS N06110 pipe in the annealed condition (temper) for general corrosion applications.

1.2 This specification covers pipe sizes in schedules shown in Table 1.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 The following precautionary caveat pertains only to the test method portion, Section 13, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet (MSDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.

TABLE 1 Dimensions of Welded Pipe^A

Note 1—The following table is a partial reprint of Table 1 of the American National Standard for Stainless Steel Pipe (ANSI B36.19).

Note 2—The decimal thicknesses for the respective pipe sizes represent their nominal wall dimensions.

^A Schedules 5S and 10S wall thicknesses do not permit threading in accordance with the American National Standard for Pipe Threads (ANSI B2.1).

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

Keywords

Nickel alloy pipe--specifications; Nickel-chromium alloys--specifications; Nickel-chromium-molybdenum-tungsten alloys; UNS N06110 (austenitic corrosion resistant Ni alloy, Allcorr); Welded Ni/Ni alloy pipe--specifications;

ICS Code

ICS Number Code 77.150.40 (Nickel and chromium products)

Citing ASTM Standards

[Back to Top]