This specification establishes the requirements for sheets and strips of copper-zirconium alloys with Copper Alloy UNS No. C15100. The material for manufacture shall be a cast bar, slab, cake, billet, or others of such purity and soundness as to be suitable for processing by hot working, cold working, and annealing to produce a uniform wrought structure in the finished product. Products shall be sampled and prepared, then tested accordingly to examine their conformance to dimensional (thickness, length, width, mass, straightness, and edges), mechanical (tensile strength, and hardness), electrical resistivity, chemical composition, and grain size requirements.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 This specification establishes the requirements for sheet and strip of Copper Alloy UNS C15100.

1.2 Values stated in inch-pound units are the standard. SI values given in parentheses are for information only.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

Keywords

copper-zirconium; sheet and strip;

ICS Code

ICS Number Code 77.150.30 (Copper products)

Citing ASTM Standards

[Back to Top]