WITHDRAWN, NO REPLACEMENT
| ||Format||Pages||Price|| |
|3||$46.80||  ADD TO CART|
This specification covered sintered Powder Metal (P/M) structural parts of substantially pure copper of two types depending on density. It is anticipated that the parts will be used in applications where high electrical conductivity is required.
Formerly under the jurisdiction of Committee B09 on Metal Powders and Metal Powder Products, this specification was withdrawn in February 2010 in accordance with subsection 10.5.3.1 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.
1.1 This specification covers sintered Powder Metal (P/M) structural parts of substantially pure copper of two types depending on density. It is anticipated that the parts will be used in applications where high electrical conductivity is required.
1.2 The values stated in inch-pound units are the standard. The SI values in parentheses are for information only and may be approximate.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B243 Terminology of Powder Metallurgy
B328 Test Method for Density, Oil Content, and Interconnected Porosity of Sintered Powder Metal Structural Parts and Oil-Impregnated Bearings
E8 Test Methods of Tension Testing of Metallic Materials
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM B715-96(2001), Standard Specification for Sintered Copper Structural Parts for Electrical Conductivity Applications (Withdrawn 2010), ASTM International, West Conshohocken, PA, 1996, www.astm.orgBack to Top