This specification covers welded tubes made of UNS N06625, UNS N06219 and UNS N08825 alloys for use in boilers, heat exchangers and condensers for general corrosion prevention in either low or high-temperature environments. This standard contains information on manufacturing, chemical composition, mechanical properties and dimensional requirements for the welded tubes.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1.1 This specification covers welded UNS N06625, UNS N06219 and UNS N08825 alloy boiler, heat exchanger, and condenser tubes for general corrosion resisting and low or high-temperature service.
1.2 This specification covers tubes 1/8 to 5 in. (3.18 to 127 mm), inclusive, in outside diameter and 0.015 to 0.500 in. (0.38 to 12.70 mm), inclusive, in wall thickness. Specification B 751 lists the dimensional requirements of these sizes. Tubes having other dimensions may be furnished provided such tubing complies with all other requirements of this specification.
1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet (MSDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B751 Specification for General Requirements for Nickel and Nickel Alloy Welded Tube
E8 Test Methods for Tension Testing of Metallic Materials
UNS N06219; UNS N06625; UNS N08825; welded tube; Nickel alloy tube--specifications; Nickel-chromium alloys--specifications; Nickel-chromium-molybdenum-columbium alloys--specifications; Nickel-iron-chromium-molybdenum-copper alloys--specifications; Udimet alloy; UNS N06219 (Ni-Cr-Mo-Si alloy, Nicrofer 6219Si); UNS N06625 (Ni-Cr alloy, Inconel 625); UNS N08825 (Ni-Fe-Cr alloy, Incoloy 825); Welded Ni/Ni alloy tube--specifications;
ICS Number Code 77.120.40 (Nickel, chromium and their alloys)
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]