This specification covers alloys UNS N08925, UNS N08031, UNS N08932, UNS N08926, UNS N08354, and UNS R20033 plate, sheet, and strip in the annealed temper. The alloys shall conform to the required chemical composition such as carbon, manganese, phosphorus, sulfur, silicon, nickel, chromium, molybdenum, copper, nitrogen, and iron. The alloys shall also conform to the required mechanical properties such as tensile strength, yield strength, elongation, and Rockwell hardness.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1.1 This specification covers alloys UNS N08925,* UNS N08031, UNS N08932, UNS N08926, UNS N08354, and UNS R20033 plate, sheet, and strip in the annealed temper.
1.2 ASTM International has adopted definitions whereby some grades, such as UNS N08904, previously in this specification were recognized as stainless steels, because those grades have iron as the largest element by mass percent. Such grades are under the oversight of ASTM Committee A01 and its subcommittees. The products of N08904 previously covered in this specification are now covered by Specifications A240/A240M and A480/A480M.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet (MSDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
A240/A240M Specification for Chromium and Chromium-Nickel Stainless Steel Plate, Sheet, and Strip for Pressure Vessels and for General Applications
A480/A480M Specification for General Requirements for Flat-Rolled Stainless and Heat-Resisting Steel Plate, Sheet, and Strip
B906 Specification for General Requirements for Flat-Rolled Nickel and Nickel Alloys Plate, Sheet, and Strip
E527 Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)
UNS N08031; UNS N08925; UNS N08926; UNS N08932; UNS N08354; UNS R20033 ; plate; sheet; strip; Nickel alloy plate/sheet/strip--specifications; Nickel-chromium alloys--specifications; Nickel-iron-chromium-molybdenum-copper-low carbon alloys--specifications; UNS N08031 (Ni-Fe-Cr-Mo-Cu, Alloy No. 31); UNS N08904 (Ni-Cr-Mo alloy); UNS N08925 (Ni-Fe-Cr-Mo-Cu-low-carbon alloy); UNS N08926 (Ni-Fe-Cr-Mo-Cu-N alloy, low C, N modified); UNS N08932 (Ni-Fe-Cr-Mo-Cu low C alloy, Creusot UR SB 8); UNS R20033 (Cr-Ni-Fe-Mo austenitic stainless steel, Alloy 33)
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]