This specification covers alloys UNS N08330 and N08332 in the form of hot-finished and cold-finished seamless pipe and tube intended for heat resisting applications and general corrosive service. The material shall be furnished in the annealed condition. The alloys shall conform to the composition limits of the material of this specification. Tensile strength, yield strength, elongation, and hardness of the material shall conform to the mechanical property requirements. Annealed alloy UNS N08332 shall conform to an average grain size set by this specification, or coarser. One test per lot is required. Flattening test shall also be performed. Each pipe or tube shall be subjected to either the hydrostatic test or to a nondestructive electric test.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 This specification covers alloys UNS N08330 and N08332 in the form of hot-finished and cold-finished seamless pipe and tube intended for heat resisting applications and general corrosive service.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet (MSDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

Keywords

high-temperature alloy; seamless pipe; seamless tube; N08330; N08332; Corrosive service applications--pipe (Ni/Ni alloy); Corrosive service applications--tube (Ni/Ni alloys); Nickel-iron alloy--specifications; Nickel-iron-chromium alloys--specifications; Nickel-iron-chromium-silicon alloys--specifications; Seamless Ni alloy pipe--specifications; Seamless Ni alloy tube--specifications; UNS N08330 (Ni-Fe-Cr alloy, RA 330); UNS N08332 (Ni-Fe-Cr-Si alloy, RA 330TX) ; ICS Number Code 8332

ICS Code

Citing ASTM Standards

[Back to Top]