| ||Format||Pages||Price|| |
|6||$45.00||  ADD TO CART|
|Hardcopy (shipping and handling)||6||$45.00||  ADD TO CART|
|Standard + Redline PDF Bundle||12||$54.00||  ADD TO CART|
This specification covers hot- and cold-finished bars and shapes of wrought nickel-iron-chromium-silicon alloys with UNS Nos. N08330 and N08332 intended for heat-resisting applications and general corrosive service. Materials shall be furnished in the heat-treated condition, except that cold-drawn hexagons may be given a cold-drawn sizing pass subsequent to the final heat treatment. Specimens shall be sampled and prepared, then tested accordingly to examine their conformance to dimensional (thickness, width, length, and angularity), mechanical (tensile and yield strengths, and elongation), chemical composition, and grain size requirements.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1.1 This specification covers wrought alloys UNS N08330 and UNS N08332 in the form of hot-finished and cold-finished bar and shapes intended for heat-resisting applications and general corrosive service.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Safety Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B536 Specification for Nickel-Iron-Chromium-Silicon Alloys (UNS N08330 and N08332) Plate, Sheet, and Strip
B880 Specification for General Requirements for Chemical Check Analysis Limits for Nickel, Nickel Alloys and Cobalt Alloys
E8 Test Methods for Tension Testing of Metallic Materials
E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
E112 Test Methods for Determining Average Grain Size
E1473 Test Methods for Chemical Analysis of Nickel, Cobalt and High-Temperature Alloys
ICS Number Code 77.150.40 (Nickel and chromium products)
UNSPSC Code 11171800(Nickel based super alloys)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM B511 / B511M-16, Standard Specification for Nickel-Iron-Chromium-Silicon Alloy Bars and Shapes, ASTM International, West Conshohocken, PA, 2016, www.astm.orgBack to Top