ASTM B469-94

    Standard Specification for Seamless Copper-Alloy Tubes for Pressure Applications (Withdrawn 2000)

    Withdrawn Standard: ASTM B469-94 | Developed by Subcommittee: B05.04

    WITHDRAWN, NO REPLACEMENT


    There is no PDF download available at this time, however you may purchase a copy of this document from the IHS Standards Store
    (Click here to view IHS phone and email contact details).



    1. Scope

    1.1 This specification establishes the requirements for seamless tubes produced from Copper Alloy UNS Nos. C19200 and C70600 for general engineering applications.

    Note 1-This tube is particularly suitable for automobile hydraulic brake lines exposed to a corrosive salt environment.

    1.2 The values stated in inch-pound units are the standard. SI values given in parentheses are for information only.

    1.3 The following hazard statement pertains only to the test method described in Sections 15.3.3, 15.3.4, and 15.3.5 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.



    Referencing This Standard

    DOI: 10.1520/B0469-94

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM B469-94, Standard Specification for Seamless Copper-Alloy Tubes for Pressure Applications (Withdrawn 2000), ASTM International, West Conshohocken, PA, 1994, www.astm.org

    Back to Top