Abstract
This specification establishes the requirements for plates, sheets, strips, and rolled bars of copper-iron alloys with Copper Alloy UNS Nos. C19200, C19210, C19400, C19500, C19700, and C19720. The material for manufacture shall be a cast bar, cake, or slab and so forth of such purity and soundness as to be suitable for processing by hot working, cold working, and annealing to produce a uniform wrought structure in the finished product. Tempers shall be available in the following: O60 (soft annealed), O61 (annealed), O50 (light annealed), O82 (annealed to temper, ½ hard), H01 (¼ hard), H02 (½ hard), H03 (¾ hard), H04 (hard), H06 (extra hard), HR02 (½ hard), HR04 (hard), H08 (spring), H10 (extra spring), and H14 (super spring). Products shall be tested and shall adhere to dimensional (mass, thickness, length, width, straightness, and edge), mechanical (tensile strength, and Rockwell hardness), electrical (resistivity and equivalent conductivity), chemical composition, and grain size requirements.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1. Scope
1.1 This specification establishes Copper Alloy UNS Nos. C19200, C19210, C19400, C19500, C19700, and C19720 plate, sheet, strip, and rolled bar.
1.2 Units—Values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units, which are provided for information only and are not considered standard.
2. Referenced Documents (purchase separately) 
The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
B193 Test Method for Resistivity of Electrical Conductor Materials
B248 Specification for General Requirements for Wrought Copper and Copper-Alloy Plate, Sheet, Strip, and Rolled Bar
B601 Classification for Temper Designations for Copper and Copper Alloys--Wrought and Cast
B846 Terminology for Copper and Copper Alloys
E8 Test Methods for Tension Testing of Metallic Materials
E54 Test Methods for Chemical Analysis of Special Brasses and Bronzes
E62 Test Methods for Chemical Analysis of Copper and Copper Alloys (Photometric Methods)
E75 Test Methods for Chemical Analysis of Copper-Nickel and Copper-Nickel-Zinc Alloys
E112 Test Methods for Determining Average Grain Size
E478 Test Methods for Chemical Analysis of Copper Alloys
E527 Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)
Keywords
copper-iron alloy plate; copper-iron alloy rolled bar; copper-iron alloy sheet; copper-iron alloy strip; UNS No. C19200; UNS No. C19210; UNS No. C19400; UNS No. C19500; UNS No. C19700; UNS No. C19720; Copper alloy plate/sheet/strip/rolled bar--specifications; Copper-iron alloy; UNS C19210; UNS C19720; UNS C19200 (high copper alloy); UNS C19400 (high copper alloy); UNS C19500 (high copper alloy); UNS C19700 (copper alloy); ICS Number Code 9720
ICS Code
DOI: 10.1520/B0465-11
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]
