Abstract
This specification establishes the requirements for copper-cobalt-beryllium alloy (UNS No. C17500), copper-nickel-beryllium alloy (UNS No. C17510), and copper-nickel-lead-beryllium alloy (UNS No. C17465) rods and bars in straight lengths. Tempers available under this specification are: TB00 (solution heat treated (A)), TF00 (precipitation hardened (AT)), TD04 (solution heat treated and cold worked: hard (H)), and TH04 (hard and precipitation heat treated (HT)). Materials shall be tested and adhere to mechanical (tensile strength and Rockwell hardness), electrical conductivity, and chemical composition requirements.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1. Scope
1.1 This specification establishes the requirements for copper-cobalt-beryllium alloy (UNS No. C17500), copper-nickel-beryllium alloy (UNS No. C17510), and copper-nickel-lead-beryllium alloy (UNS No. C17465) rod and bar in straight lengths.
1.2 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units, which are provided for information only and are not considered standard.
1.3 The following hazard statement pertains only to the test method portions of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) 
The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
B193 Test Method for Resistivity of Electrical Conductor Materials
B194 Specification for Copper-Beryllium Alloy Plate, Sheet, Strip, and Rolled Bar
B249/B249M Specification for General Requirements for Wrought Copper and Copper-Alloy Rod, Bar, Shapes and Forgings
B601 Classification for Temper Designations for Copper and Copper Alloys--Wrought and Cast
B846 Terminology for Copper and Copper Alloys
E8 Test Methods for Tension Testing of Metallic Materials
E18 Test Methods for Rockwell Hardness of Metallic Materials
E1004 Test Method for Determining Electrical Conductivity Using the Electromagnetic (Eddy-Current) Method
Keywords
beryllium copper bar; beryllium copper rod; UNS C17500 bar; UNS C17500 rod; UNS C17510 bar; UNS C17510 rod ; UNS C17465 bar; UNS C17465 rod; Copper alloy rod/bar/shapes--specifications; Copper-beryllium alloys--specifications; UNS C17500 (beryllium copper); UNS C17510 (beryllium copper) ;
ICS Code
ICS Number Code 77.150.30 (Copper products)
DOI: 10.1520/B0441-04R10
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]
