1.1 This specification establishes the requirements for copper-nickel-silicon alloy rod and bar produced from Copper Alloy UNS No. C64700 in straight lengths.

1.2 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

B193 Test Method for Resistivity of Electrical Conductor Materials

B249/B249M Specification for General Requirements for Wrought Copper and Copper-Alloy Rod, Bar, Shapes and Forgings

B601 Classification for Temper Designations for Copper and Copper Alloys--Wrought and Cast

B846 Terminology for Copper and Copper Alloys

E8 Test Methods for Tension Testing of Metallic Materials

E8M Test Methods for Tension Testing of Metallic Materials [Metric]

E54 Test Methods for Chemical Analysis of Special Brasses and Bronzes

E478 Test Methods for Chemical Analysis of Copper Alloys

Keywords

copper-nickel-silicon alloy bar; copper-nickel-silicon alloy rod; UNS C64700 bar; UNS C64700 rod; Bronze rod/bar/shapes--specifications; Copper alloy rod/bar/shapes--specifications; Copper-nickel alloys--specifications; Copper-nickel-silicon alloy; Silicon bronze--specifications; UNS C64700 (silicon bronze) ;

ICS Code

ICS Number Code 77.150.30 (Copper products)

Citing ASTM Standards

[Back to Top]