ASTM B328-96(2003)e1

    Standard Test Method for Density, Oil Content, and Interconnected Porosity of Sintered Metal Structural Parts and Oil-Impregnated Bearings (Withdrawn 2009)

    Withdrawn Standard: ASTM B328-96(2003)e1 | Developed by Subcommittee: B09.04

    WITHDRAWN, REPLACED BY B962, B963


      Format Pages Price  
    PDF 4 $45.60   ADD TO CART

    Active (view current version of standard)

    ASTM License Agreement


    Withdrawn Rationale:

    This test method covers determination of the density, oil content, and interconnected porosity of sintered bearings and structural parts with or without oil impregnation.

    Formerly under the jurisdiction of Committee B09 on Metal Powders and Metal Powder Products, this test method was withdrawn in April 2009, because the test method has been split into two new standards B962 and B963 respectively.

    1. Scope

    1.1 This test method covers determination of the density, oil content, and interconnected porosity of sintered bearings and structural parts with or without oil impregnation.

    1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.



    DOI: 10.1520/B0328-96R03E01

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM B328-96(2003)e1, Standard Test Method for Density, Oil Content, and Interconnected Porosity of Sintered Metal Structural Parts and Oil-Impregnated Bearings (Withdrawn 2009), ASTM International, West Conshohocken, PA, 2003, www.astm.org

    Back to Top