ASTM B102-00(2005)

    Withdrawn Standard: ASTM B102-00(2005) Standard Specification for Lead- and Tin-Alloy Die Castings (Withdrawn 2011)

    Developed by Subcommittee: B02.02

    WITHDRAWN, NO REPLACEMENT

    Buy Standard (PDF)
    4 pages
    $44.40


    Withdrawn Rationale:

    This specification covers die castings produced from five alloys whose primary metal is either lead or tin. Table 1 lists the designations for these alloys as well as their chemical compositions.

    Formerly under the jurisdiction of Committee B02 on Nonferrous Metals and Alloys, this specification was withdrawn in May 2011 in accordance with section 10.5.3.1 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.

    1. Scope

    1.1 This specification covers die castings produced from five alloys whose primary metal is either lead or tin. lists the designations for these alloys as well as their chemical compositions.

    1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet (MSDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B23 Specification for White Metal Bearing Alloys (Known Commercially as Babbitt Metal)

    B275 Practice for Codification of Certain Nonferrous Metals and Alloys, Cast and Wrought

    E8 Test Methods for Tension Testing of Metallic Materials

    E23 Test Methods for Notched Bar Impact Testing of Metallic Materials

    E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

    E46 Test Methods for Chemical Analysis of Lead- and Tin-Base Solder

    E88 Practice for Sampling Nonferrous Metals and Alloys in Cast Form for Determination of Chemical Composition

    Federal Standards

    Fed.Std.No.123 Marking for Shipment (Civil Agencies)

    Military Standards

    MIL-P-116 Methods of Preservation


    DOI: 10.1520/B0102-00R05

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top